Tabla de contenido
Idiomas disponibles
Idiomas disponibles
iNSTALLATiON
STEP
7
Install
the
Light
and
Lens
• Install a 75 watt maximum light bulb in the socket.
The light will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.
• Apply slight pressure on the sides of the lens and
slide the tabs into the slots in the end panel. (See
illustration.)
• For convenience,
the lens may be installed
after Adjustment
Step 4 on page 30.
• To remove, reverse the procedure. Use care to
avoid snapping off lens tabs.
• Use standard neck Garage Door Opener bulbs for
replacement.
Light
Lens
'
Lens
Slot
75 Watt Max.
Light Bulb
Lens
Tab
Lens
Guide
iNSTALLATiON
STEP
8
Attach
the
Emergency
Release
Rope
and
Handle
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 1" from the end of the rope to prevent
slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above
the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal
the cut end with a match or lighter to prevent
unra veling.
. To prevent possible SERIOUSINJURYor DEATHfrom
a falling garage door:
- If possible, use emergency release handle to
disengage trolley ONLYwhen garage door is
CLOSED.Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
. NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
Trolley
Emergency
..................
l_
_
Overhand
E_
Knot
Release Handle
)_
19
Tabla de contenido
