Install The Lights And Lens; Attach The Emergency Release Rope And Handle - Craftsman 139.53927 Manual Del Propietário

INSTALLATION STEP 10
Install the Lights and Lens
• Install a 100 watt maximum light bulb in each
socket. The lights wilt turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFE
• Insert bottom lens tabs into slots on chassis. Tilt
towards chassis to engage top tabs, then drop
down gently into place. (See illustration.)
• To remove, depress both top lens tabs. Tilt lens
slightly outward and down, then pull out to clear
bulbs. Use care to avoid snapping off bottom lens
tabs.
NOTE: Use only standard light bulbs. The use of
short neck or speciafity light bulbs may overheat the
endpanel or light socket.
Top Lens Tab
Lens
Bottom
Chassis Slots
"--I rll ok
_'_0 0 0 0 0 0 0 _1
12_
Top
Lens Tab
Bottom Insert Bottom
Chassis Slot Lens Tabs First
INSTALLATION STEP 11
Attach the Emergency Release
Rope and Handle
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 1" (2.5 cm) from the end of the rope to
prevent slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet (1.8 m)
above the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal
the cut end with a match or lighter to prevent
unraveling.
• To prevent possible SERIOUSINJURY or DEATHfrom
a falling garage door:
- If possible, use emergency release handle to
disengage trolley ONLYwhen garage door is
CLOSED.Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVERuse emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
Trolley
Release Arm
Overhand
Knot
Release Handle
23