Using The Wall-Mounted; Door Control; To Open The Door Manually; Disconnect The Trolley - Craftsman 139.53976SRT Manual Del Propietário

Using the Wall-Mounted
Door Control
THE PASSIVE INFRARED CONTROL CONSOLE
Press the push bar to open or close _'_,_ Push
the door. Press again to reverse the __'_,__---Bar
door during the closing cycle or to I _:_-_l Detector
stop the door while it's opening.
_
_.,__Switch
_ _,_,._ Light
This door control contains a motion
h___nn.kq_ _:'4""C_ J_
FButt°n
detector that will automatically turn Lock Button
on the light when it detects a person
entering the garage. This feature can be easily turned
off for extended work light use.
Light feature
Press the Light button to turn the opener light on or
off. It will not control the opener lights when the door
is in motion. If you turn it on and then activate the
opener, the light will remain on for 4-1/2 minutes.
Press again to turn it off sooner.
The 4-1/2 minute interval can be changed to 1-1/2,
2-1/2, or 3-1/2 minutes as follows: Press and hold the
Lock button until the light blinks (about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat
again for a 3-1/2 minute interval, etc., up to a
maximum of four blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you first disable the motion sensor
See Automatic Light Feature, following.
• Automatic Light Feature: The opener light will
turn on automatically when a person enters the
garage. When a person walks in front of the door
control, the light will come on for five minutes, then
shut off. This feature works by detecting body heat
and may not work in temperatures around 100°R
To disable this feature, slide the Detector Switch on
the right side of the door control down (off).
We recommend that you disable the motion sensor
when using the opener lights as working lights.
Otherwise, they will turn off automatically if you are
working beyond the sensor's range.
• Energy Saving Feature: This door control senses
the brightness inside the garage, and will not turn
the light on if it is already bright enough. If the light
sensor turns on the light when it is not needed, or
does not turn it on when it is dark, the sensitivity
can be adjusted. Remove the push bar cover by
gently prying off the top edge with a coin or
screwdriver. Underneath there is a dial below the
green light on the right side. Use a small
screwdriver to turn the dial by 1/4 turns
(counterclockwise) to make the light come on, or
(clockwise) to make the light go off. Replace the
cover by inserting top tabs and snapping into
place.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door will
open and close from the Door Control, the Outdoor
Key Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push bar indicator light will flash as
long as the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push bar light will stop flashing. The
Lock feature will also turn off whenever the learn
button on the motor unit panel is activated.
Additional feature when used with the
3-function hand-held remote
To control the opener lights:
In addition to operating the door, you may program
the remote to operate the lights.
1. With the door closed, press and hold a small
remote button that you want to control the light.
2. Press and hold the Light button on the Console.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights flash, release all buttons.
To Open the Door Manually
32
• To prevent possible SERIOUSINJURY or DEATHfrom a
falling garage door:
- If possible, use emergency release handle to disengage
trolley ONLYwhen garage door is CLOSED.Weakor
broken springs or unbalanced door could result in an open
door falling rapidly and/or unexpectedly.
- NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed }:_ _t_
if possible. Pull down on the
emergency release handle (so
that the trolley release arm snaps _-_" Trolley
into a vertical position) and lift the
_
_
Release aim
feature
/u
(DlnscManlnect(In Manuat
door manually. The lockout I!,_
Posttlon)
prevents the trolley from _ Positi,
reconnecting automatically, and LOCKOUTPOSmON
the door can be raised and (MANUAL D ISCONNECT)
lowered manually as often as necessary.
TO RE-CONNECT THE TROLLEY:
Pull the emergency release
handle toward the opener at a
45 ° degree angle so that the
trolley release arm is horizontal.
The trolley will reconnect on the
next UP or DOWN operation,
either manually or by using the
door control or remote.
Release
Emergency "_',q_. Arm
Release Handle "_% _.,
(Pull at 45 ° angle_ _ ;m,
TO RECONNECT