Install The Hardware; Prepare The Network Cable; Install The Wall Bracket - Axis P13-E Serie Guia Del Usuario

Page 8

Install the hardware

The instructions below describe the installation of AXIS P1343-E/P1344-E/P1346-E.

Prepare the network cable

If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently force the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the supplied screwdriver.
Notes:
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.

Install the wall bracket

1. Use the supplied drill template to prepare a wall, ceiling, or pole for installation of the wall
bracket.
2. Route the network cable through the wall bracket, the rubber gasket should be on the bracket
adapter end of the wall bracket, see illustration on page 7.
3. Install the wall bracket on a wall, ceiling, or pole and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
Notes:
• The weight of the camera is shown in the table below. Check that the material is strong enough to
support this weight.
Model
AXIS P1343-E
AXIS P1344-E
AXIS P1346-E
• For more technical specifications, please see the User's Manual, available on the CD included in this
package, or from www.axis.com
AXIS P13-E Network Camera Series Installation Guide
Weight
3090 g (6.8 lb.)
3120 g (6.9 lb.)
3130 g (6.9 lb.)