Battipav Class Manual De Instrucciones página 40

GB
MANUFACTURER AND MACHINE
The nameplate shown is fitted directly on the machine. It indicates all the references and information necessary for safe operation.
31
A Machine model
B Item
C Serial number
D Power supply voltage
E Power supply frequency
F Current absorption
G Installed power rating
H Tool rotation speed
I Class of protection
L Starter capacitor
INSTALLATION
TRANSPORT
The CLASS/CLASSplus machine can be easily moved by using the transport handles.
Before carrying the machine make sure that:
• the motor carriage is locked by means of the locking knob located on the slide rail;
1
• the legs are in transport position;
• the motor head is locked by means of the locking lever;
• the tube-holder rod is out of its housing.
2
To move the machine, use a four-arm tie rod with the capacity to lift 200 kg or at least 20% more than the machine weight,
by making use of the hooks in the transport handles.
HANDLING
By using the "transport wheels" accessory (standard for Art. 6xxxx1), the machine can be moved with the aid of a second person.
IN ORDER NOT TO COMPROMISE THE MACHINE STABILITY, KEEP STRICTLY TO THE FOLLOWING PROCEDURES.
WITH THE AID OF A SECOND PERSON, HOLD THE MACHINE DURING THE WHEEL KIT INSTALLATION OPERATIONS.
When the machine is in working position (See paragraph: Positioning):
a) loosen the left leg locking pin (motor side);
3
b) lift the leg and put it in the wheel support;
c) lock the leg with the relative locking pin;
3
d) tighten the wheel support setscrew;
e) repeat the operation for the right wheel.
IN ORDER TO FACILITATE THE CLASS/CLASSplus MACHINE MOVEMENT IN THE YARD, WE RECOMMEND TO BRING IT IN A
LOWERED POSITION:
a) loosen the leg locking pins on the front side, one at a time, holding the machine from the transport handles;
4
b) lower the machine front side, making the legs slide inside the supports until the leg middle hole matches the hole of the
supports (see picture 5);
c) lock the legs by means of the relevant leg locking pins;
d) repeat the operations indicated in points (a), (b), (c) for the rear side.
5
MOVE THE MACHINE
POSITIONING
Place the machine on a stabile surface. To place the machine in working position, proceed as follows:
6
THE MOTOR HEAD IS LOCKED BY MEANS OF THE RELEVANT LOCKING KNOBS LOCATED ON THE SLIDE RAIL
6
a) The motor head inclination adjustment lever is properly tightened. 7
a) put the leg locking pins in release position;
b) by means of the transport handles, lift one side of the machine until the working position .
7
FOR CORRECT MACHINE POSITIONING, MAKE SURE THAT THE LEG UPPER HOLE MATCHES THE LEG COUPLING HOLE,
8
BEFORE FINALLY LOCKING IT.
8
c) lock the legs one at a time.
HOLD THE MACHINE DURING THE LOCKING PHASES.
40
M IP Level
N Year of manufacture
O Max tool diameter
P Internal tool diameter
Q Accessories
R Accessories
S Manufacturer's name
T Manufacturer's name and address
U Certification Marks
Battipav srl