Wiring The Beacon - Federal Signal 154XST Serie Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Wiring the Beacon

The Model 154XST Series LED Beacon should be installed per the
NEC or CEC, STATE and LOCAL CODES. Alternate installation
locations and/or orientations should only be performed with the
approval of the authority having jurisdiction. In addition, the unit
can be mounted using an optional ceiling mount or optional wall
mount.
EXPLOSION HAZARD—To maintain the vapor-tight enclosure,
do not damage the dome or threads while disassembling or
reassembling the unit. Lubricated threaded joints exposed
for long periods of time may attract small particles of dirt or
other foreign materials. Housing and cover joints should be
reassembled immediately, with all the threads fully engaged.
SHOCK HAZARD—To avoid electrical shock hazards, do not
connect wires while power is applied.
SHOCK/FIRE HAZARD—This is a four-wire device, and
when installed, all four wires must be terminated. Failure to
terminate both red and black wires will result in a shock or
fire hazard.
REVERSE POLARITY/MISWIRING—The 154XST is not polarity
sensitive, but MAY BE DAMAGED by incorrect electrical
hookup. Damage will result if the voltage rating of the
particular model is exceeded.
NOTE: Wiring must comply with the National Electrical Code
or Canadian Electrical Code and the local authority having
jurisdiction.
The 154XST unit is provided with four 24-inch leads; two red, and
two black.
Models 154XST and 154XST-S
11