HQ-Power HQMX11010 Manual De Usuario página 7

19. Routing buttons Z1 to Z3 (with indicating LEDs) to assign the stereo channels 1 to 4
individually to the three master channels.
o
o
o
20. LED level indications for the master channels.
21. 3-way equalizer for the master channels TREB, MID and BASS.
22. Balance controls for the master channels.
23. Mono/stereo selector switches for the master channels.
24. Level controls for the master channels.
25. PFL buttons for the master channels. With the button pressed (LED above it lights
up), the signal of the corresponding master channel can be monitored ahead of the
master level control (24) via headphones connected to the jack PHONES (4).
Rear Panel
26. On-off switch.
27. Mains cable for connecting the unit to a mains socket 230 V~/50 Hz.
28. Inputs PHONO (phono jacks) for the stereo channels 1 and 2 for connecting
turntables with magnetic system.
29. Outputs of the three master channels (optionally XLR jacks (bal.) or phono jacks,
mono or stereo, depending on the corresponding selector switch (23)) for
connecting amplifiers or other units with line input level (e. g. sound recorder,
second mixer):
o
o
o
30. Inputs LINE and CD (phono jacks) for the stereo channels 1 to 4 for connecting
units with line level outputs (e. g. MD recorder, CD player).
31. Ground clamping screw for connected turntables.
32. Input jacks (6.3 mm jacks, bal.) for the two microphone channels as an alternative
to the microphone inputs (5) on the front panel.
5. Installation
1. Switch off the appliance prior to connecting any units or changing any existing
connections.
2. Connect the stereo audio sources to the corresponding RCA input jacks of
the channels 1 to 4 (white jack = left channel; red jack = right channel):
Connection of two microphones
Connect a microphone for announcements to the microphone channel MIC 1
and another microphone to the second microphone channel MIC 2. Either
connect the corresponding microphone to the XLR jack (5) on the front panel
or to the corresponding 6.3 mm jack (31) on the rear panel.
V. 02 – 10/05/2021
Z1 pressed: input channel
Z2 pressed: input channel
Z3 pressed: input channel
outputs Z1 for master channel ZONE 1.
outputs Z2 for master channel ZONE 2.
outputs Z3 for master channel ZONE 3.
units with line level output (e.g. tuner, CD/MP3 player, tape deck) to the jacks
o
LINE or CD (28);
turntables with magnetic system to the jacks PHONO (29). Connect the
o
ground connections of the turntables to the clamping screw GND (30).
HQMX11010
switched to channel ZONE 1.
switched to channel ZONE 2.
switched to channel ZONE 3.
7 ©Velleman nv