General Guidelines - HQ-Power HQMX11010 Manual De Usuario

3.

General Guidelines

•
Refer to the Velleman
manual.
•
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4. Description
Front Panel
1. BNC jack for connecting a gooseneck light (12 V/5 W max.).
2. MP3 display.
3. Volume control for the headphone output (4).
4. 6.3 mm stereo headphones jack (impedance ≥ 8 Ω) for pre-fader listening to the
stereo channels 1 to 4 or for monitoring the master channels.
5. XLR inputs (bal.) for the microphone channels. As an alternative, use microphone
inputs (31) on the rear panel.
6. Switches for the microphone channels. With the switch in the ON position, the input
level of the corresponding microphone is attenuated by 15 dB.
7. Gain controls for the input amplification of the microphone channels.
8. 2-way tone control for the microphone channels TREB and BASS.
9. Controls for placing the mono signals of the microphone channels on the stereo
base.
10. Talk-over switch for the microphone channel MIC 1. With the button pressed (LED
above it lights up), the levels of the stereo channels 1 to 4 are automatically
attenuated by 16 dB when announcements are made via the microphone.
11. Level controls for the microphone channels.
12. On-off switches for the microphone channels. With the button pressed (LED above it
lights up), the corresponding microphone is switched on.
13. Routing buttons Z1 to Z3 (with indicating LEDs) to assign the two microphone
channels together to the three master channels.
o
o
o
14. Input selector switches for the stereo channels 1 to 4.
15. Gain controls for the input amplification of the stereo channels 1 to 4.
16. PFL buttons for the stereo channels 1 to 4. With the button pressed (LED above it
lights up), the signal of the corresponding channel can be monitored ahead of the
channel fader (18) via headphones connected to the jack PHONES (4).
17. PEAK LEDs for the stereo channels 1 to 4. If the LED lights permanently, the
corresponding channel is overloaded.
18. Level controls (faders) for the stereo channels 1 to 4.
V. 02 – 10/05/2021
®
Service and Quality Warranty on the last pages of this
Z1 pressed: microphone channels switched to channel ZONE 1.
Z2 pressed: microphone channels switched to channel ZONE 2.
Z3 pressed: microphone channels switched to channel ZONE 3.
HQMX11010
6 ©Velleman nv