Description And Size; Description; Size; Ventilation Of The Area In Which The Appliance Is To Be Installed - deville C07783 Guía De Utilización

3 - DESCRIPTION AND SIZE

3.1 DESCRIPTION (Fig. 1)
The main elements of the stove are shown below :
(1) Lagging decoration
(2) Loading door
(3) Control door
(4) Top
(5) Duct Ø 153
A secondary air inlet is integrated in the upper section of the door window to maintain it clean and
ensure improved wood combustion.
The thermostat, located on the right-hand side of the appliance, enables the selection of the burning
rate.
Stove net weight :
3.2 SIZE (Fig. 2)
Outer dimensions (mm)
Overall
Overall

3.3 - VENTILATION OF THE AREA IN WHICH THE APPLIANCE IS TO BE INSTALLED

•
The appliance needs air in addition to the air required by the statutory air change rate. This is obligatory when the
dwelling includes mechanical ventilation.
•
The air intake should give directly to the outside or should be located in an area ventilated to the outside ; it
should also be protected by a grille.
•
The air supply exit must be located as close to the appliance as possible. It must be able to be capped when it
emerges directly into the room. While the appliance is working, make sure that it is free of any obstruction.
•
The air intake section should be at least equal to one-quarter of the section of the smoke flue with a minimum of :
2
- 50 cm for use with the door closed only
•
It may be necessary to stop the extractor of the mechanical ventilation so as to avoid smoke coming back into the
room when the door is opened.
3.4 - WALLS IN THE VICINITY OF THE APPLANCE
•
Place the stove at a distance of at least 600mm from the back and side walls of the room and from all
combustible materials.
•
To protect the floor from heat radiation, and from any possible falling fuel, put the appliance on a reflective metal
screen (or a tiled floor) covering the entire surface of the floor beneath and in front of the appliance.
•
The appliance must be installed on a floor with a sufficient load-bearing capacity. If an existing construction does
not satisfy this prerequisite, adequate measures must be taken (for example, the installation of a load distribution
plate) in order to enable the floor to support the appliance.

4 - STOVE OPERATING CONDITIONS

C07753 Stove approx. 130 kg
C07783 Stove approx. 113 kg
C07784 Stove approx. 130 kg
•
C07783 STOVE
Width
920
•
C07753 - C07784 STOVE
Width
910
13
(6) Rear protection shield
(7) Thermostat control
(8) Handle
(9) Strip
(10) Panel
Height
832
Height
865
Depth
415
Depth
415