Check For Gas Leaks - Weber SPIRIT 210 Guia Del Propietario

CHECK FOR GAS LEAKS

Do not use an open fl ame to check for gas leaks. Be sure
there are no sparks or open fl ames in the area while you
check for leaks. Sparks or open fl ames will result in a fi re or
explosion which can cause serious bodily injury or death and
damage to property.
WARNING: You should check for gas leaks every time you
disconnect and reconnect a gas fi tting.
Note: All factory-made connections have been thoroughly checked for gas leaks. The
burners have been fl ame-tested. As a safety precaution however, you should recheck
all fi ttings for leaks before using your Weber
loosen or damage a gas fi tting.
WARNING: Perform these leak checks even if your barbecue
was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Make sure side burner is OFF (See LEAK CHECK PREPARATION). Remove valve control
knob and screws. Remove porcelain top.
To perform leak checks: Slide back the collar of the quick disconnect. Push male fi tting
of the hose into the quick disconnect, and maintain pressure. Slide the collar closed.
If it does not engage or lock, repeat procedure. Gas will not fl ow unless the quick
disconnect is properly engaged.
Turn on gas supply.
Check for leaks by wetting the connections with the soap and water solution and
watching for bubbles. If bubbles form or if a bubble grows, there is a leak.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
WARNING: Do not ignite burners when leak checking.
Check:
1) Hose to manifold connection.
WARNING: If there is a leak at connection (1), retighten the
fi tting with a wrench and recheck for leaks with soap and
water solution. If a leak persists after retightening the fi tting,
turn OFF the gas. DO NOT OPERATE THE GRILL. Contact
the Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.
®
com .
2) Valves to manifold connection
3) Hose to quick disconnect connection
WARNING: If there is a leak at connections (2) or (3) turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact the
Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.
®
com .
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water.
WWW.WEBER.COM
®
GAS INSTRUCTIONS
DANGER
®
gas barbecue. Shipping and handling may
(1)
SPIRIT E/SP-
210 & 310
*The grill illustrated may have slight
differences than the model purchased.
9
9
(2)
(1)
(2)
(3)