Troubleshooting - Silverline 262705 Traducción Del Manual Original

GB
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension
cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry
cloth. If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant

Troubleshooting

Problem
No operation
Cutting performance poor
Power tool vibrating excessively
in use
Mitre or Bevel angle difficult to adjust
8
Possible cause
Plug fuse
Worn brushes
Power tool fault
Teeth worn or damaged
Incorrect saw blade type
Incorrect blade specification
Incorrectly fitted blade
Saw blade distorted, bent or damaged
Saw blade incorrectly mounted
Machine fault
Build-up of sawdust
Original Instructions
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• To replace the brushes, remove the brush access plugs from both sides of the machine.
Remove the worn brushes and replaced with new. Replace brush access plugs.
Alternatively, have the machine serviced at an authorised service centre
Storage
• The cutting head can be lowered and secured by the Latching Pin (36) to make the saw
a smaller size for storage. Store this tool carefully in a secure, dry place out of the reach
of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools
Solution
Replace fuse
Have brushes replaced by an authorised Silverline service centre
Contact an authorised Silverline service centre
Replace blade
Replace blade with correct type for material being sawed
Ensure blade meets the required blade specification for this mitre saw
Remove blade and refit exactly as per the instructions in this manual
Replace blade immediately
Re-fit blade exactly as per the instructions in this manual
Contact an authorised Silverline service centre
Vacuum up sawdust