Troubleshooting - Silverline 953452 Manual De Instrucciones

EN
• To cut thin sheet metal, sandwich the sheet between
hardboard or plywood and clamp the layers to prevent
vibration and tearing of the metal
Accessories
•
A full range of accessories including blades, is available from
your Silverline stockist
• Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING: Always disconnect the tool from the power supply, before
cleaning or carrying out maintenance.
General inspection
• Regularly check that all the fixing screws are tight. They may
vibrate loose over time
•
Repairs should be carried out by an authorised Silverline
service centre.
Lubrication
•
Lubricate all moving parts with a suitable lubricant spray, at
regular intervals
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection
and gloves when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause
internal parts to wear quickly, and shorten the device's
service life
•
Clean the body of your tool with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry
cleaning is not sufficient, a mild detergent on a damp cloth
is recommended
•
Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through
the ventilation holes (where applicable)
Brushes
•
Over time the carbon brushes inside the motor may
become worn
• Excessively worn brushes may cause loss of power,
intermittent failure, or visible sparking
•
If you suspect that the brushes may be worn, have them
replaced at an authorised service centre
Contact
For technical or repair service advice, please contact the helpline on (+44)
1935 382 222
Web: silverlinetools.com/en-GB/Support
UK Address:
Toolstream Ltd, Boundary Way, Lufton Trading Estate, Yeovil, Somerset.
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V. De Keten, 00004, 5651 GJ, Eindhoven, Netherlands
Storage
• Store this tool carefully in a secure, dry place out of the
reach of children
• For long-term storage, remove batteries and store
separately
Disposal
Li-ion batteries should not be disposed of with household waste. If you do
not know of a li-ion battery recycling centre in your area, contact your local
authority or original dealer for advice on disposal of li-ion batteries.
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
•
Do not dispose of power tools, batteries or other waste
electrical and electronic equipment (WEEE), with household
waste
•
Contact your local waste disposal authority for information
on the correct way to dispose of power tools and batteries

Troubleshooting

Problem Possible cause
Battery completely
discharged
Defective Battery
No function when
ON/OFF Trigger
Defective ON/OFF
Switch (8) is
Trigger Switch
operated
Carbon brushes
Saw Blade (1) not
suitable for the
material being cut
Slow cutting
performance
Saw Blade blunt
Saw Blade not
suitable for the
material being cut
Too much pressure
Saw Blade (1) blunts exerted on to the
quickly
No cutting
fluid/cooling agent
used when cutting
silverlinetools.com
Original Instructions
Solution
Recharge Battery or
replace with a fully
charged battery
Replace Battery
Have the ON/OFF
Trigger Switch
replaced by an
authorised Silverline
service centre
Have the carbon
brushes replaced by
an authorised
worn
Silverline service
centre
Fit compatible saw
Blade
Fit new saw Blade
Fit compatible saw
Blade
Use less pressure
whilst moving the
tool tool
Use a suitable
cutting fluid when
cutting metal
metal
12