Idiomas disponibles
Idiomas disponibles
M.-Nr. 11477230
Risk of injury due to excessive physical strain
WARNING
Risk of injury due to excessive physical strain.
Spinal injuries.
A
The relation of the weight of the machine to the physical strength of the technician must be taken into account.
For machine weight details, see the operating instructions.
Stand preparation
A
Use two 6x12 screws to attach each of the clamping plates to the rear of the stand; see Fig. 1.
The arrow embossed on the top of the stand points to the front; see Fig. 1.
A
Level the stand on the floor.
The flooring must be level and dry with no traces of dirt or grease.
A
Unscrew the front panel.
A
Fill all of the canisters with water and seal them tightly. Leave the drain valve closed at all times.
A
Place 2 canisters into the stand and line them up with the rear of the stand.
A
For an APCL023 stand, place 2 additional canisters into the stand and line them up with the front of the stand.
A
Place the last two canisters into the stand.
Be very careful when placing the canisters into the stand. Leave the drain valves closed at all times.
Check that the fill level in the system is constant at regular intervals.
Installing a washer on the stand
A
Install the clamps on the front of the stand and fasten them in the appropriate holes; see Fig. 2.
A
Secure each clamp to the stand with one M6x30 bolt (1), two galvanized B6.4 washers (2) and an M6 nut (3). Do not
tighten the nuts yet; see Fig. 3.
A
Unscrew the washing-machine feet by at least 5mm.
A
Place the washing machine on the stand and slide its rear feet into the clamping plates.
A
Level the washing machine on the stand.
A
Use the clamps to secure the washing machine to the front feet; see Fig. 3.
A
Install a second M6 nut (4) on each of the feet to counter the first nut; see Fig. 3.
A
Screw one M6x20 screw (1) into each of the clamping plates and tighten; see Fig. 4.
A
Screw the front panel of the stand back into place.
Installing a dryer on the stand
A
Unscrew the dryer feet by at least 5mm.
A
Place the dryer on the stand and slide its rear feet into the clamping plates.
A
Level the dryer on the stand.
A
Screw one M6x20 screw (1) into each of the clamping plates and tighten; see Fig. 5.
A
Screw the front panel of the stand back into place.
en-US
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
17 von 55
18.03.2021
