Sub-Zero ICB424 Instrucciones De Instalación página 21

Model ICBWS-30 Installation
Position the Unit
Use an appliance dolly to move the unit near the rough
opening. Model ICBWS-30 is equipped with rollers, so it
can be moved into position more easily.
Shut off power to the electrical outlet. Plug the power
supply cord into the 15 amp grounded outlet and roll the
unit into position. Be sure that the anti-tip brackets are
properly engaged.
IMPORTANT NOTE: If possible, keep the door closed until
the unit is properly anchored.
IMPORTANT NOTE: If for any reason the unit has been laid
on its back or side, you must allow the unit to stand upright
for a minimum of 24 hours before connecting power.
Protect any finished flooring before moving the unit
into place
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the
floor once the unit is in position.
Level the Unit
Once the unit is in position, extend the front leveling legs
down by turning the legs clockwise to adjust the height.
The rear height adjustment can be made from the front of
the base. Use a 10 mm socket to adjust the rear rollers.
Turn the 10 mm hex bolt clockwise to raise the unit or
counterclockwise to lower it. Refer to the illustration below
for location of the rear roller base adjustment.
IMPORTANT NOTE: Be sure to reference leveling of the unit
to the floor and not to surrounding cabinetry. This could
affect the operation of the unit, such as door closing.
FRONT
LEVELING LEG
REAR
ADJUSTMENT
Rear roller base adjustment.
Door Adjustment
The door of the model ICBWS-30 can be adjusted in three
ways: In and out, side to side tilt, and up and down.
Regardless of the adjustment being made, start by slightly
loosening the two upper hinge bolts on the upper hinge
plate using a 13 mm wrench. Refer to the illustration below.
IN AND OUT ADJUSTMENT
Refer to the illustration for location of the bolt for in and
out door adjustment. To adjust a left-hinge door; using a
5 mm allen wrench, turn the bolt clockwise to bring the
handle side of the door inward, and counterclockwise to
move the handle side of the door outward. Reverse the
directions for a right-hinge door.
SIDE TO SIDE TILT ADJUSTMENT
Refer to the illustration for location of the bolt for side to
side tilt door adjustment. To adjust a left-hinge door; using
a 10 mm wrench, turn the bolt clockwise to raise the
handle side of the door up and counterclockwise to tilt the
handle side of the door down. Reverse the directions for a
right-hinge door.
UPPER IN AND OUT
HINGE BOLTS ADJUSTMENT
SIDE TO SIDE
TILT ADJUSTMENT
Upper hinge bolts. Door adjustment bolts.
subzero.com
Door height adjustment.
DOOR HEIGHT ADJUSTMENT
To adjust a left-hinge door; using a 6 mm allen wrench,
turn the bolt clockwise to raise the door and counterclock-
wise to lower the door. Refer to the illustration above.
Reverse the directions for a right-hinge door.
21