Assembly Instructions - Troy-Bild TB415CS Manual Del Operador

INSTALL CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment shield on
your unit is not installed or if you ever need to re-install it.
WARNING:
To prevent serious personal injury, never
operate the trimmer without the cutting attachment
shield in place.
1. Place the cutting attachment shield onto the shaft housing. Be
sure the guard mounting bracket slides into the slot on the edge
of the cutting shield. Rotate the shield into place,
counterclockwise. The holes in the guard mounting bracket and
cutting attachment shield will line up (Fig. 1).
Cutting
Attachment
Shield
2. From inside the cutting attachment shield, push the square bolt
through the hole until the threaded end protrudes through the guard
mounting bracket (Fig. 2).
Guard Mounting Bracket
Cutting Attachment
Shield
3. Put the washer on the bolt, then screw the wing nut onto the
bolt and tighten. Figure 3 shows the installation process from
underneath the unit.

ASSEMBLY INSTRUCTIONS

Shaft Housing
Guard
Mounting
Bracket
Fig. 1
Washer
Wing Nut
Square
Blot
Fig. 2
Screw
Fig. 3
ADJUSTING THE D-HANDLE
1. Locate the wing nut on the D-Handle. Loosen the wing nut
enough to loosen the D-Handle (Fig. 4).
NOTE: Do not remove wing
nut, washer, or bolt.
2. Rotate the D-Handle to the
upright position on the
front side of the shaft
housing (Fig. 4).
NOTE: The D-handle should
slant towards the
powerhead of the unit.
3. Hold the unit in the
operating position (Fig. 13).
If necessary, reposition the
D-handle to the location
that provides the best grip.
4. Tighten the wing nut until
the D-Handle is secure.
5
Fig. 4