Tabla de contenido
2.
Prepare the Bottom Track
Measure distance "D" above curves
in the corners.
Mesurer la distance "D" au-dessus des
courbes des angles.
Mida la distancia "D" por encima de las
curvas en las esquinas.
Measure here.
Measure here.
Mesurer ici.
Mesurer ici.
Mida aquí.
Mida aquí.
D
Curved Base
Angled Base
Base courbée
Base inclinée
Base curva
Base en ángulo
IMPORTANT! Risk of product damage. If your shower has a curve in the corners
where they meet the sidewalls, be sure to measure from wall to wall above the
curves. Failure to measure above the curve or angle could result in the bottom track
being cut too short.
Determine the pivot end of the bottom track. If you are not sure which end is the
pivot end, position the bottom track on the ledge with the front side of the track
toward the outside of the shower.
Measure from wall to wall at the flattest part of the shower ledge (Distance D).
Subtract 9/16" (1.4 cm) from dimension "D." The resulting dimension is the
bottom track cut length.
IMPORTANT! Measure from the pivot side of the bottom track. Mark and cut the
strike side.
Mark the strike side at the determined distance (see the previous section to
determine the strike side).
NOTE: For best results use a miter box and 32-teeth per inch hacksaw to make the
cut.
Cut the bottom track at the mark. Do not cut the pivot end.
File the rough edges smooth where the bottom track was cut, taking care to avoid
damaging finished surfaces.
Sterling
Important: Do not cut on the pivot side.
Important: Ne pas découper sur le côté pivot.
Importante: No corte el extremo pivotante.
For Right Pivots
Pour pivots droits
Para pivotes a la derecha
Pivot End
Extrémité pivot
Extremo pivotante
9/16" (1.4 cm)
D
Front Side of
Bottom Track
Avant du rail
inférieur
Frente del carril
9/16" (1.4 cm)
inferior
For Left Pivots
Pour pivots gauche
Para pivotes a la izquierda
5
Pivot End
Extrémité pivot
Extremo pivotante
1063213-2-B
Tabla de contenido
