Sun Enterprise 220R Manual De Instalación Y Montaje página 19

2. Attach one slide assembly to the right rack mounting rail, and the other slide
assembly to the left rack mounting rail. See the next figure.
a. With the help of an assistant, position the slide assembly on the inside of the
rack enclosure with the short mounting bracket facing the front of the rack.
Count the holes so that each slide assembly is installed at the same height
front-to-back and side-to-side in the rack or use the Rack Buddy as described
in Step 1.
b. Attach the front short mounting bracket of one slide assembly to the front rail
on the rack.
Secure the slide bracket assembly to the front mounting rail using two
Phillips 10-32 panhead screws. Use the holes marked in Step 1. Finger-tighten
the screws. Do not tighten the screws completely until all the screws are in
place and the slide assemblies are level.
c. Attach the long mounting bracket of the same slide assembly to the back rail of
the rack.
Secure the slide bracket assembly to the back mounting rail using two Phillips
10-32 panhead screws. Finger-tighten the screws. Do not tighten the screws
completely until all the screws are in place and the slide assemblies are level.
Chapter 2 Rack Installation en-15