How To Check The Running Mat For Proper Lubrication; Belt Adjustment; Belt Tracking Adjustment - Techness RUN 200 Manual De Usuario

See below procedures for lubricating:
1. Use a soft, dry cloth to wipe the area between the belt and deck.
2. Spread lubricant onto the inside surface of belt and deck evenly (make sure the machine is
turned off and power is disconnected).
3. Periodically lubricate the front and rear rollers to keep them at their peak performance.
If the treadmill belt/deck/roller is kept reasonably clean it is possible to expect over 1200 hours
before additional re-lubing is necessary.

4.4. How to check the running mat for proper lubrication

1. Disconnect the main power supply.
2. Fold the treadmill up into the storage position.
3. Feel the back surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend you use a silicone based spray to lubricate your Lifespan Treadmill. This Can
be purchased from your local sports Retailer or a local hardware store.

4.5. Belt Adjustment

Belt Tension Adjustment-It is very important for joggers and runners in order to provide a smooth,
steady running surface. Adjustment must be made from the right and left rear roller in order to
adjust tension with the Hexagonal Wrench provided in the parts package. The adjustment bolt is
located at the end of the rails as noted in diagram below:
Left bolt
Note: Adjustment is thru the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and
left bolt clockwise reasonably and inspect for proper tension. When an adjustment is made to the
belt tension, you must also make a tracking adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure.

4.6 Belt Tracking Adjustment

This treadmill is designed to keep the belt reasonably centered while in use. It is normal for some
belts to drift near one side while the belt is running with no one on it. After a few minutes of use,
the belt should have a tendency to center itself. If during use, the belt continues to move toward one
side, adjustments are necessary. The procedures are as below:
▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
14
Right bolt