Safety Instructions; Product Assembly - cecotec Ready Warm 800 Thermal Manual De Instrucciones

ENGLISH

2. SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance. Keep this instruction manual
for future reference or new users.
• Make sure that the mains voltage matches the voltage stated on the rating label of the
appliance and that the wall outlet is grounded.
• This appliance is intended for household use only. Do not use for industrial or commercial
purposes.
• Check the power cord regularly for visible damage. If the cord is damaged, it must be
replaced by the official Technical Support Service of Cecotec in order to avoid any type of
danger.
• Do not cover the device in order to avoid overheating.
• The installation of this appliance on the wall of a bathroom always must be done at a
distance where no person in the shower or in the bath may reach it.
• Do not use the device directly on the floor without installing the legs.
• Do not place the appliance close to heat sources, flammable substances, wet surfaces
where it can fall or be pushed into water or allow it to come into contact with water or
other liquids. Do not operate outdoors.
• Do not place the appliance immediately below a power socket.
• Allow the device to operate at maximum temperature for 2-3 hours in a ventilated place
in order for the device to eliminate all manufacturing wastes.
• The product's surface will reach high temperatures during operation. Avoid skin from
getting in contact with it and use the handle to move it.
• Use it always with the fins in upright position.
• Keep the packaging materials out of the reach of children, the could be dangerous.
• The appliance is not intended to be used by children under the age of 8. It can be used by
children over the age of 8, as long as they are given continuous supervision.
• This appliance can be used by children aged 8 and above, and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, as long as
they have been given supervision or instruction concerning the use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the appliance.
• Supervise young children to make sure that they do not play with the appliance. Close
supervision is necessary when the appliance is being used by or near children.

3. PRODUCT ASSEMBLY

FLOOR ASSEMBLY
Place the stand on the bottom part of the device, each one on one side, and screw them. Make
18 READY WARM THERMAL
sure they are properly fixed.
WALL ASSEMBLY
• Before installing it, make sure the appliance is placed at a minimum safety distance of 20
cm from any obstacle (walls, shelves, floor...).
• Drill 2 holes on the wall with a distance of 140 mm between them.
• Attach the wall supports (5) to the wall using the studs and screws provided. Make sure
the smaller-diameter side of the supports is hung from the wall.
• Screw the wall-support accessory (6) onto the 2 holes on the back-bottom part of the
device. Make sure the side with just 1 hole is against the wall.
• Hang the appliance from the supports.
•
Once hung on the wall, mark the free hole of the wall-support accessory (6).
• Remove the appliance from the wall, drill a hole where the mark is and introduce the
corresponding stud.
• Finally, hang the appliance on the brackets and screw the mounting plate to the wall.
5
6
4. OPERATION
AUTOMATIC LOCK
• The buttons on the device's control panel will block if during operation no button is
pressed for 1 minute.
• To unlock it, press (-) for 3 seconds.
THE ELECTRIC RADIATOR CAN BE OPERATED MANUALLY OR PROGRAMMED:
1. MANUAL
• 3 operating modes
• Day mode : the temperature can be set from 5 to 35 ºC.
• Night mode : the temperature can be set from 5 to 35 ºC.
• Anti-frost mode : the temperature can be set from 5 to 15 ºC.
WARNING:
for the device to be able to operate, the set temperature must always higher than the
ENGLISH
READY WARM THERMAL 19