Kitchen Brains TRACKER 42 Guia De Funcionamiento página 13

Operating a TRACKER ™ Multi-Display Timer
CONNECTING TRACKER TO TRACKER
Setting Master
to Satellite
Communications
NOTE: Addresses shown are
examples only.
This document contains confidential information. The dissemination, publication, copying, or duplication of this document or the software described herein without prior written authorization is strictly prohibited.
Kitchen Brains © 2012 | www.KitchenBrains.com | 229-51277 G
Master to Satellite
If one TRACKER is set as a satellite, the master will communicate only the hold time
to the satellite. The satellite can operate normally, but no communication can be made
from the satellite to the master.
Example: Set one TRACKER address to 1 and the other to 2. Address 1 is the master
and address 2 is the satellite (1 is 'MADD 1' and 2 is 'SADD 2').
Programming the Master
OR
Press both keys to modify the address
at the same time number of the Master
and hold for 3
seconds
Currently
programmed
address is
displayed
Programming the remote Satellite
OR
Press both keys to modify the address
at the same time number of the Remote
and hold for 3 Satellite
seconds
Currently
programmed
address is
displayed
OR
to set to change to Remote change the Remote
remote Satellite Satellite address to a
mode different number
OR
to set to change to Remote change the Remote
remote Satellite Satellite address to the
mode same as the Master
OR
to complete
programming
the Master and
return to idle
mode
OR
to complete
programming
Remote Satellite
and return to idle
mode
Page 13 of 32