Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating a TRACKER
™
Multi-Display Timer
CONNECTING TRACKER TO TRACKER
Setting Master to Master
Communications
NOTE: Addresses shown are
examples only.
This document contains confidential information. The dissemination, publication, copying, or duplication of this document or the software described herein without prior written authorization is strictly prohibited.
Kitchen Brains © 2012 | www.KitchenBrains.com | 229-51277 G
Hold or Count Down time information can be communicated between two TRACKERs by hooking up a
cable to each of the TRACKERs. This cable is available from Kitchen Brains (part number 141-15730).
There are four (4) option modes for TRACKER to TRACKER communication: 1. Master to Master;
2. Master to Satellite; 3. Master to RQI; and 4. None
Master to Master
If both TRACKERs are set up for 'master to master', when a product key is pressed, one TRACKER time
will display on the other TRACKER. Either TRACKER can cancel the timing cycle.
Example: Each TRACKER must be set to a different address. Set one TRACKER address to 1 and the
other to 2. Address 1 is the Master and address 2 is the remote Master.
Programming the First Master
OR
Press both keys
to modify the address
at the same time
number of the Master
and hold for 3
seconds
Currently
programmed
address is
displayed
Programming the Second remote Master
OR
Press both keys
to modify the address
at the same time
number of the Remote
and hold for 3
Master
seconds
Currently
programmed
address is
displayed
OR
to set
to change to Remote
change the Remote
remote
Master
Master address to a
mode
different number
OR
to set
to change to Remote
change the Remote
remote
Master
Master address to
mode
the same as the First
Master
OR
to complete
programming
First Master
and return to
idle mode
OR
to complete
programming
Remote Master
and return to idle
mode
Page 12 of 32
Tabla de contenido
