USRobotics 5454 Guía Breve De Instalación página 13

2. If you still are not communicating with the access point, restore the fac-
tory default settings of the access point to reactivate it.
N o t e : When you restore the factory default settings, the access point
will lose all custom settings.
To restore the factory default settings, use a small object such as a paper
clip to press in and hold the reset button on the back of the access point
for 5 to 10 seconds.
After you restore the access point, reconfigure the access point by per-
forming "Step Two: Set Up the Access Point" on page 4.
My client does not establish a wireless connection to the Wireless
Access Point after I changed the settings
In the configuration utility for your wireless adapter:
1. Ensure that you are connecting to the Wireless
ing the WLAN MAC address.
2. Ensure that the same encryption options, and their passphrase or key, are
used on both the wireless adapter and the access point. If you change the set-
ting on the access point, you must also change the settings of every wireless
adapter that is intended to connect to the access point.
I cannot access the configuration pages
1. In your Web browser, make sure that you are entering the correct IP address
for the access point. If you are using a Windows operating system, you can
find the IP address by running the locator. To run the locator:
Windows Vista or XP: click Windows Start > All Programs > USRobotics
Network Device Locator and click Next.
Windows 2000: click Windows Start > Programs > USRobotics Network
Device Locator and click Next.
2. If you are trying to access the configuration pages wirelessly, try to access
them with a wired connection as follows:
A. Using a computer connected by Ethernet cable to the same networking
device as the access point, start a Web browser.
B. Enter the IP address of the access point and press enter.
If you can access the configuration pages with a wired connection, you
are exeriencing a connectivity issue. See step 5 under "General" on
page 7.
If you cannot access the configuration pages with a wired connection,
restore the factory default settings of the access point to reactivate it.
N o t e : When you restore the factory default settings, the access
point will lose all custom settings.
N
dx Access Point by verify-
English
N
dx
9