Steamfast SF-145 F Guía De Usuario página 9

FLOOR LIGHTS
A unique feature of your Clean Mist Steam Mop are the front-mounted LED Floor Lights, which attrac-
tively and conveniently illuminate dark or difficult-to-see floor areas. Simply press down on the Floor
Light Switch at any time while unit is powered on to activate the Floor Lights.
NOTE: Floor Lights will only function when the unit's main power is on (On/Off Switch has been
pressed and red Power Indicator Light is illuminated).
STEAM MOPPING
Before operating, make sure Microfiber Pad is properly attached (Page 7), Boiler is filled with
water (Page 8), and if desired, Solution Tank is filled with Cleanfast Hard Floor Solution (Page 8).
1. For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug power cord
into a convenient electrical outlet.
2. Place Resting Pad on floor, so that textured side faces upward. Rest Mop Head on top of Pad, in
order to help protect floor surface from excess heat and moisture during heat-up period.
3. Using your foot, gently press down on On/Off Switch until it clicks. Red Power Indicator Light will
illuminate to show that unit is receiving power. At the same time, green Heating Indicator Light will
illuminate to show that Boiler is heating.
4. After approximately 3 minutes of heating time, unit will begin emitting steam.
5. Remove unit from Resting Pad, and begin mopping.
Refer to Page 10 for a listing of floor surfaces that are recommended for cleaning with your
Clean Mist Steam Mop.
6. For best results, mop using a steady back-and-forth motion over the floor, working your way
backwards in order to avoid walking over the freshly mopped area.
IMPORTANT: To avoid warping or damage caused by heat and moisture, do not use on unsealed
hardwood or unglazed ceramic surfaces. Steam may remove the sheen from some floors that
have been treated with wax.
Never allow Clean Mist Steam Mop to rest idle on floor surfaces while still on – prolonged
exposure to steam in a single area may discolor or damage some floors. If it becomes
necessary to stop mopping at any time, always turn unit off and place back on Resting Pad.
7. To clean exceptionally tough dirt, stains and scuffs, pretreating with Cleanfast HARD FLOOR Solution is
recommended. To use Solution, first be sure that Solution Tank is filled (refer to Adding Cleanfast
Hard Floor Solution procedure on Page 8). Then, using your foot, gently press down on Solution
Spray Button – a burst of Solution will be sprayed from Solution Nozzle onto floor in front of unit.
Repeat as necessary to thoroughly cover dirty area, then continue mopping as normal.
NOTE: For very stubborn scuffs and stains, allow Cleanfast HARD FLOOR Solution to soak
for 1-2 minutes after spraying, then continue mopping as normal.
8. Once all water has been used, green Heating Indicator Light will turn off to show that Boiler is empty.
If you wish to continue mopping, first turn unit off by pressing down gently on On/Off Switch until it
clicks, then unplug power cord from outlet. Refer to Adding Water procedure on Page 8 to refill Boiler.
9. The Microfiber Cloth will absorb dirt and moisture during mopping. However, when you are finished
you may find some residual moisture has been left behind. In this case, it is recommended to allow
floor time to air-dry. A fan may be directed towards mopped area to facilitate drying.
10. Once your mopping tasks are completed, place unit back on Resting Pad and turn it off by pressing
down gently on On/Off Switch until it clicks. Unplug power cord from outlet, then refer to procedures
on Page 11 for proper storage and care of your Clean Mist Steam Mop.
9