Steamfast SF-145 F Guía De Usuario página 8

ADDING WATER
1. Make sure On/Off Switch is set to "off" position (red
Power Indicator Light will not be illuminated) and
power cord is unplugged.
REFILLING: If unit has been in use, allow a
minimum of 5 minutes cooling time.
2. Carefully remove Boiler Cap by unscrewing it in a
counter-clockwise direction (FIGURE 4-A).
REFILLING: If unit has been in use, be sure Boiler
is completely empty to prevent overfilling.
3. Fill included Measuring Cup with 8.5 oz. (250 ml.)
water, and pour into Boiler through Boiler Fill Hole
(FIGURE 4-B).
NOTE: In order to minimize potential mineral
build-up and prolong the life of your Clean Mist
Steam Mop, it is recommended that distilled or
de-mineralized water be used in the Boiler.
If distilled water is not available, then Boiler
should be cleaned frequently in order to remove
mineral build-up. Refer to Page 11 for details.
4. For maximum usable water (10 oz. / 300 ml.), fill
Measuring Cup with another 1.5 oz. (50 ml.) of water,
and add into Boiler.
5. Replace Boiler Cap by screwing it into Boiler Fill Hole
in a clockwise direction until tight. Unit is now ready
to begin steaming – refer to Page 9 for operating
instructions.
ADDING CLEANFAST
HARD FLOOR SOLUTION
1. Remove Solution Tank Plug to expose Solution Tank
fill hole.
NOTE: Solution Tank Plug does not need to be
unscrewed or otherwise unlocked – simply grasp
it and pull it out.
2. Insert Funnel into Solution Tank fill hole.
3. Pour Cleanfast HARD FLOOR Solution into the
Solution Tank, up to a maximum of 6.75 oz. (200 ml.).
4. Remove Funnel and reinsert Solution Tank Plug.
CAUTION: Cleanfast HARD FLOOR Solution
should only be used in Solution Tank. Pouring
Solution into Boiler could result in reduced
effectiveness, damage to unit or possible injury.
8
Using Your
Clean Mist Steam Mop
4-A
4-B
FIGURE 4
FIGURE 5