RECOMMENDED FLOOR SURFACES
Below is a listing of some of the most common floor surfaces that the Clean Mist Steam Mop
is ideal for cleaning. If you have a question about a floor surface that isn't listed below, please
contact our Consumer Service Department:
The Clean Mist Steam Mop is perfect for these floor surfaces:
•
Sealed Hardwood
•
Stained Concrete
•
Sealed Laminate
•
Linoleum
•
Ceramic
•
Granite
•
Marble
•
Slate
•
Tile
•
Carpeting / Rugs (using Carpet Glider accessory)
IMPORTANT: Do not use on unsealed hardwood or unglazed ceramic surfaces. Surfaces
that are not properly sealed may be warped or damaged by exposure to heat and moisture.
Care should also be taken when steaming sealed hardwood floors, as prolonged exposure
to steam in a single spot may cause damage and discoloration. To avoid this, keep the
Clean Mist Steam Mop in constant motion on these surfaces, and place it back on Resting
Pad when idle.
Steam may remove the sheen from some floors that have been treated with wax.
Extremely rough textured floors may tear or damage Microfiber Pads.
Before steaming any carpeting, it is recommended to consult the manufacturer's guidelines.
For carpets in question, always test on a small inconspicuous area before proceeding.
ABOUT CLEANFAST HARD FLOOR SOLUTION
Cleanfast HARD FLOOR Solution is an advanced, steam-enhanced cleaner. Not to be confused
with typical harsh household chemicals, HARD FLOOR Solution contains only harmless proprietary
surfactants and water. Surfactants, or surface acting agents, break down dirt's bond with your
hard floors and makes even the toughest scuffs and stains a snap to wipe away. Because of
it's unique properties, HARD FLOOR Solution is actually enhanced by steam. Use it to on your
floors while steam mopping, and marvel at results that are even faster and more effective than
what either steam or solution alone are capable of. Non-toxic and biodegradable, with no harmful
bleach or other additives.
10
Using Your
Clean Mist Steam Mop