Braun Pulsonic 9585 Manual De Instrucciones página 13

If the station selects one of the required cleaning
programs, it will not start unless you press the
«start cleaning» button
results, we recommend cleaning after each
shave.
Whilst cleaning is in progress, the respective
cleaning program diode will blink. Each cleaning
program consists of several cycles, where
cleaning fl uid is fl ushed through the shaver head
and a heat drying process dries the shaver.
Depending on the program selected the total
cleaning time will range from 32 to 43 minutes.
The cleaning programs should not be
interrupted. Please note that whilst the shaver is
drying, the shaving head may be hot and wet.
When the program is fi nished, the blue «clean»
diode will light up. Your shaver is now clean and
ready for use.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The diodes of
the Clean&Renew station and the shaver display
turn off.
Shaver display
The shaver display
of the battery. During charging or when using the
shaver, the respective green battery segment will
blink. When fully charged both charge segments
will light up continuously, provided the shaver is
switched on or connected to an electrical outlet.
The red low charge segment fl ashes when
the battery capacity has dropped below 20%,
provided the shaver is switched on. The
remaining capacity will then be suffi cient for
2 to 3 shaves.
Charging information
• A full charge provides up to 50 minutes
of cordless shaving time. This may vary
according to your beard growth.
• The best environmental temperature for
charging is between 5 °C to 35 °C. Do not
expose the shaver to temperatures higher
than 50 °C for extended periods of time.
4
. For best shaving
r
shows the charge status
high high
low low
clean clean
eco eco
normal normal
intensive intensive
auto select auto select
13