Alarm Messages - Bentel Security B-TEL99 Manual De Instalación Y Usuario

ALARM MESSAGES

The Alarm messages are sent to the programmed telephone numbers. The B-TEL99 can store:
r Two Dedicated Messages (16 seconds per message), one for each alarm channel;
r
A Long Common Message (32 seconds) for both channels, according to the setting of option n. 1 (see "OPTIONS").
r
A Short Common Message (16 seconds) for both alarm channels + 2 brief dedicated messages (8 seconds per
message), one for each alarm channel (see "OPTIONS").
Default setting The B-TEL99 message memory is empty (no default setting).
n n
Long Common Message - Short Channel 1 Message - Brief Dedicated Channel 1 Message
The alarm channel 1 message/s is/are sent to the programmed telephone numbers (max. 7), when the alarm channel
1 cycle is triggered.
Record To record an alarm message for alarm channel 1 proceed as follows:
Access the programming phase...
b
1 Press
b
2 Press
again
1
3 Press
e
4 Press
to start recording
Stand close the microphone 5 (at approx. 10 cm.) and, for best recording results, record
the message in a deep tone of voice. *If option "1" is programmed as "Long Common
Message" (common to both channels) the maximum recording time will be 32 seconds.
In the event of an alarm, the same message will be sent for alarm channel 1 and alarm
channel 2.
F If option "1" is programmed as "Two Dedicated Messages" the maximum recording
5
time will be 16 seconds.
F If option "1" is programmed as "Short Common Message+2 brief dedicated
messages" the maximum recording time will be 8 seconds.
F The message countdown will be shown on the display in division of ten 0 - 9 - 8 and
so forth (o stands for 10).
Playback To playback the alarm channel 1 message proceed as follows:
Access the programming phase...
b
1 Press
1
2 Press
to select the alarm channel 1 message
e
3 Press
to start playback
36
b
ð
b
ð
1
ð
e
ð
ð
b
ð
1
ð
e
ð
Telephone Dialler B-TEL99
-
b
b
1
E
8
7
.
.
.
2
1
-
b
1
-