auna KaraBanga Manual Del Usario página 35

Singing along from aux input sources
This karaoke unit features an AUX-IN jack for connecting your iPod, MP3 player or other digital music
player .
1 . Connect the headphone jack of your external device to the AUX IN jack located on the lower side of
this unit (The connection cable is not included) .
2 . Turn on the unit player and it will enter the AUX function mode once an external device is plugged
into the AUX IN jack .
3 . Connect the line out or headphone jack of your external audio device (e .g . a CD player, MP3 player,
iPhone, iPod, etc...) to the unit with a suitable audio cable (not included) .
4 . Select your favorite song on your external audio device to play . You may need to adjust the output
volume of your external audio device if the headphone jack is used for making the connection .
5 . Turn on your microphone and start singing . Adjust the MASTER VOLUME and/or MIC VOLUME if
necessary .
6 . You may also use the BALANCE and ECHO CONTROLS to enhance your singing experience .
7 . Turn off both devices after us.
NOTE: Once the AUX IN jack has been plugged into, the unit automatically enters the AUX
mode no matter what position the Function Selector is in. Remember to disconnect the Aux
In cable from the unit after use in order to listen to the CD or USB input again.
Using the unit as a public address system
This unit can also be used as a PA (Public Address System) .
Note: To prevent feedback or whistling from occurring, please be sure that the microphone is not held
too close to unit's speaker .
1 . With unit stopped at CD or USB mode, unplug any 3 .5mm audio cable (not included) connected to
the AUX IN JACK previously.
2 . Turn on your MICROPHONE (one included) and start your performance . Adjust the MASTER
VOLUME, MIC VOLUME and ECHO control if necessary .
LED light show
• The LED light shows inside the speaker and in the lower corners of the unit are created automatically
based on the music source being played at the time
• To turn off the LED light show, press the LIGHT ON/OFF to OFF .
• To turn on the LED light show, press LIGHT SHOW Switch to ON .
Note: If the brightness is glaring, turn on room lights or turn off LED light show
35