Installation Procedure - Wagan Tech SmartAC 425W Manual De Usuario

®
SmartAC 425W Power Inverter by Wagan Tech

Installation Procedure

1. Mount the inverter in a secure location. If the inverter is to be mounted on a
wall, mount it horizontally. Make sure that the front and rear of the inverter
has free air flow.
2. Make sure the ON/OFF switch located on the front panel of the inverter is
in the OFF (O) position.
3. Connect the cables as follows:
• If using the DC Plug Adapter Cord—Up to 180W Output:
i. Connect the red (+) and black (−) terminals of the supplied DC Plug
Adapter Cord to the red (+) and black (−) terminals on the rear of the
inverter.
• Be sure to connect them into the correct polarity terminals on the
rear of the inverter. Reverse polarity connection will blow the
fuse in the inverter and can permanently damage the inverter.
Damage caused by reverse polarity will void the warranty.
ii. Connect the Plug end of the DC Adapter Cable into your vehicle's 12V
DC accessory outlet. You may need to place the ignition switch to
Accessory Position if the vehicle engine is not operating.
• If using the Battery Clip Adapter Cord—Up to 425W Output:
i. Connect the Negative (−) cable end to the inverter terminal and
battery's Negative Terminal. Make sure you have good, secure
connections.
ii. Attach the positive cable to the Positive (+) DC connector on the
battery and then the inverter. Make sure the connections are tight and
secure .
4. Turn on the inverter from the Front Panel ON/OFF Switch.
5. Make certain that the green Operating LED is lit and the red FAULT LED
indicator is not lit.
7
www.wagan.com
®