Sears Craftsman 919.167240 Manual Del Operador página 8

Installing Handles, Wheels, and Molded
Foot Bumpers
clearance, stability or support for pulling
the unit up and down stairs or steps. The
unit must be lifted, or pushed up a ramp.
1. Submerge handle grip into warm soapy water to
make installation easier. Remove handle grip from
soapy water and slide onto handle.
2. Slide handle through holes in compressor saddle
onto tabs. Secure with screws, one on each side.
Screw
Handle
side of the outfit when installing the wheels
because the compressor will have a ten-
dency to tip over.
D21996
The wheels and handle
do not provide adequate
Compressor Saddle
Tab
It will be necessary to
brace or support one
3. Install one shoulder bolt and one nut for each
wheel. Tighten securely. The outfit will sit level
if the wheels are properly installed.
Nut
4. Clean and dry underside of air tank leg opposite
wheels. Remove the protective strip from the
adhesive backed molded foot bumpers. Attach
the foot bumpers to the bottom of leg on each
end. Press firmly into place.
Molded Foot Bumpers
8-Eng
Wheel
Shoulder Bolt