Cleaning And Maintenance - ALFA GIOTTO Manual Del Usario

CLEANING AND MAINTENANCE

- It is recommended regular maintenance by a qualified technician.
- Turn off the gas oven and allow it to cool before cleaning.
- To clean the oven do not use oven detergents, abrasive detergents (kitchen detergents) or that contain citrus
products, or scouring pad.
- The gas burner should be cleaned periodically by carefully sucking up any cooking residues.
- When cleaning valves and burners, be careful not to damage the burner.
- The refractory stones of the oven floor wear out with use. Alfa Pro provides the stones as spare parts.
- Thermometer - clean with warm water and soap with a soft plastic scouring pad.
- Oven - remove any residues from the burners with a brush.
- Do not enlarge burner holes (openings).
- Stainless steel surfaces - wash with a soft cloth and a solution of soap and water. Make sure to rub following
the grain of the stainless steel. Never use detergents containing acid, white spirit or xylene. Rinse well after
cleaning the oven.
HOW TO KEEP STAINLESS STEEL UNALTERED
Making the steel shine is very easy. Just wash it with water and soap, rinse out with water and dry properly. In
case of resistant residuals, it is possible use a non metal brush.
- If the oven is exposed in a sea side, in order to prevent corrosion and fouling, it is recommended to frequently
clean the oven with fresh water.
- If traces of rust begin to appear, clean with a polishing brush and apply a thin coat of vaseline.
- Apply a light coat of vaseline to make the metal shine.
GAS BURNER DISASSEMBLY AND CLEANING
The gas burner should be cleaned periodically by carefully sucking up any cooking residues.
When cleaning valves and burners, be careful not to damage the burner.
Before cleaning is necessary to remove the burner from the oven by running the following procedure:
1. Remove the knob (a).
2. Unscrew the screw (b).
3. Remove the cover (c) by unscrewing the 2 screws.
4. Remove the gas box (d) to discover the connection of the cable piezoelectric ignition (e).
5. Disconnect the two cables piezoelectric ignition. If necessary, remove the protective casing unscrewing the
screw (f), and then remove the burner.
To replace the burner just perform the procedure in reverse.
FRONT BACK
EN
23