Medtronic MiniLink REAL-Time Manual Del Usaurio página 8

MP6025647-2AF1 / A
5 If the transmitter light does not flash, disconnect it from the sensor, wait for several
seconds and then reconnect. If the transmitter light still does not flash, charge the
transmitter.
6 After the transmitter light flashes green, use your pump to communicate with the
sensor. For more instructions, see the user guide for your pump.
7 After the transmitter successfully sends sensor data to the pump, attach the adhesive
tab from the Enlite sensor (MMT-7008) to the transmitter.
8 [Optional]: Apply occlusive dressing over the transmitter and the sensor.
Disconnecting the transmitter from the sensor
1 Carefully remove any occlusive dressing from the transmitter
and sensor.
2 Remove the sensor's adhesive tab from the transmitter.
3 Hold the transmitter as shown, and pinch the flexible side arms
of the sensor between your thumb and forefinger.
4 Gently pull the transmitter away from the sensor.
Bathing and swimming
After the transmitter and sensor are connected, they form a water-tight seal to a depth of
eight feet (2.4 meters) for up to 30 minutes. You can shower and swim without removing
them. No occlusive dressing is needed.
Tester
The tester is used to test the transmitter to make sure it is working.
Connecting the tester
1 Hold the transmitter and the tester as shown. Line up the flat
side of the tester with the flat side of the transmitter.
2 Push the tester into the transmitter until the flexible side arms of
the tester click into the notches on both sides of the transmitter.
3 Within 20 seconds the green light on the transmitter will flash
for about 10 seconds when properly connected.
4 Check the sensor icon on the pump to ensure that the
transmitter is sending a signal (see the user guide for your
pump).
-6-