Technical Data - SUHNER UBC 10-R Documentación Técnica

Technical Data

Power Input
Power Output
No load speed
Belt speed
Belt length
Belt width
Belt thickness
Belt clamping force
adjustable
Sound pressure level
according to EN 50 144
Vibration according to EN 50 144
Weight without cord set
Double Insulated Class
Voltage (refer to Spare parts list)
Machine components
1 Gear head
2 Mounting flange for Belt Grinder
3 Allen screw M 5 x 16 for spring tension ad-
justment
4 Hex. Allen wrench M 4
5 Variable speed selector
6 On/off switch
7 Drive wheel
8 Belt tracking nut M 5
9 Optional Hex. nut
10 Lock-in screw M 8
11 Tension spring Hex Allen set screw
12 Threaded pin M8 x 12 to adjust tension
13 Hex. locking nut
14 Contact wheel
Suitable Tools
15 Selection of contact arms, refer to spare
parts list or catalog
16 Selection belts, see catalog
Safety Instructions
• Observe accurate mounting of belts.
4
500 Watt
300 Watt
4 000 - 10 000 rpm
6.5 - 15.5 m/s
520 mm/ 20 1/2"
3 - 19 mm/ 1/8 - 3/4"
up to 4 mm/ 5/32"
from 4 - 9 kg
77 dB(A)
< 2.5 m/s
1.8 kg
II
several
• Use clamps or vise to hold work.
• The grinder operator shall wear working glo-
ves, safety goggles or face shield at all times
when the grinder is in operation.
• If noise level exceeds 85 dB(A) at the work
station, sound insulation and hearing protec-
tion measures must be taken by the operater.
• For additional personal protection, it is advi-
sable to connect tool to a ground fault circuit
interrupter,(only in damp areas).
• Do not treat any material containing asbestos.
• Hold power tools by insulated gripping sur-
faces when performing an operation where
the cutting tool may contact hidden wiring
or its own cord. Contact with a „live" wire will
make exposed metal parts of the tool „live"
and shock the operator.
For additional safety instructions refer to enclosed
2
brochure EW 39 210 01.
Before Start-up
• Before connecting tool to a power source,
be sure the voltage supplied is the same as
specified on the name plate of the tool. The
power supply should not vary more than 10%
above or below the voltage indicated on the
nameplate. • ON-OFF switch
Before connecting power cord to receptacle,
make sure that switch 6 is in the Off -0- Positi-
on.
Operation conditions and instructions
This tool is equipped with an electronic variable
speed tachometer selector and an overload cut-
out switch, which operates as follows:
Starting current limitaion
Electronically controlled soft starting provides for
jerk-free starting of the machine.
Temperatur-dependent overload protection
For protection against overheating, when a critical
temperature is reaches the electronic safety func-
tion switches to the cool-down mode.
The machine then continues to run at approx. 2' 4 00
rpm and the elctronic constant-speed control is
deactivated. After a cool-down time of approx. 10-
20 s the machine is again ready for operation. turn
the machine OFF and back ON again to activate
the electronic constant-speed control.With the ma-
GB