Maintenance; Oven Window; Leveling Legs - JENN-AIR SLIDE-IN Serie Guia Del Usuario

M
AINTENANCE
O D
VEN OOR
CAUTION
• NEVER place excessive weight on
or stand on an open oven door. This
could cause the range to tip over,
break the door, or injure the user.
• NEVER attempt to open or close
door or operate oven until door is
properly replaced.
• NEVER place fingers between hinge
and front oven frame. Hinge arms
are spring mounted. If accidentally
hit, the hinge will slam shut against
oven frame and could injure your
fingers.
TO REMOVE:
1. When cool, open the oven door to the
broil stop position (opened about four
inches).
2. Grasp door at each side. Do not use the
door handle to lift door.
3. Lift up evenly until door clears hinge
arms.
TO REPLACE:
1. Grasp door at each side.
2. Align slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hinge
arms until the door is completely seated
on the hinges. Push down on the top
corners of the door to completely seat
door on hinges. Door should not ap-
pear crooked.
NOTE: The oven door on a new range may
feel "spongy" when it is closed. This is
normal and will decrease with use.
O W
VEN INDOW
TO PROTECT THE OVEN DOOR
WINDOW:
1. Do not hit the glass with pots, pans,
furniture, toys, or other objects.
2 Do not close the oven door until the
oven racks are in place.
Scratching, hitting, jarring or stressing the
glass may weaken its structure causing an
increased risk of breakage at a later date.
L L
EVELING EGS
• Be sure the anti-tip bracket secures one
of the rear leveling legs to the floor. This
bracket prevents the range from acciden-
tally tipping.
The range should be leveled when installed.
If the range is not level, turn the plastic
leveling legs, located at each corner of the
range, until range is level.
LEVELING LEG
LEVELING LEG
20
O
VEN
To assure the proper replacement bulb is
used, order bulb from Maytag Customer
Service. Call 1-800-688-8408, ask for part
number 74004458 - halogen bulb.
• Disconnect power to range before
replacing light bulb.
• Allow oven to cool before replacing
light bulb.
• Make sure bulb cover and bulb are
cool before touching.
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, use fingertips to
grasp edge of bulb cover. Pull out and
remove.
2. Carefully remove old bulb by pulling
straight out of ceramic base.
3. To avoid damaging or decreasing the life
of the new bulb, do not touch the bulb
with bare hands or fingers. Hold with a
cloth or paper towel. Push new bulb
prongs straight into small holes of
ceramic base.
4. Replace bulb cover by snapping into
place.
5. Reconnect power to the range. Reset
clock.
ANTI-TIP BRACKET
ANTI-TIP BRACKET
L
IGHT
CAUTION