Leggett & Platt Performance Serie Manual Del Usaurio página 20

SCAPE REMOTE CONTROL PROGRAMMING (separating 2 bases)
Separate Two Bases - for independent adjustable base movement,
perform the following numbered procedure.
STEP 1
Unplug both bases from electrical power outlet. Position
both bases on their sides, in close proximity to each other.
CAUTION: AT LEAST TWO PEOPLE ARE RECOMMENDED
FOR HANDLING AND MOVING ADJUSTABLE BASE.
STEP 2
Locate control box on both bases. Locate dual sync cable
(FIGURE 20).
STEP 3
Remove the male plug of dual sync cable from "3
Multifunction" port of control box of both bases
(FIGURE 20).
FIGURE 20
DUAL SYNC
CABLE
STEP 4
Turn both bases over so they are resting on their legs.
CAUTION: AT LEAST TWO PEOPLE ARE RECOMMENDED
FOR HANDLING AND MOVING ADJUSTABLE BASE.
STEP 5
Plug base 1 into electrical power outlet. On the control
box for base 1, using a pointed object, push the learn port
in two times in rapid succession. You will hear an audible
click after each push. Then, the indicator light will light up
(FIGURE 21).
20
Performance Models Scape/Scape+ Owners Manual 99301472-c
"3 MULTIFUNCTION"
PORT
MALE PLUG
CONTROL BOX
REMOTE CONTROL 1
REMOTE CONTROL 2
FIGURE 21
STEP 6
On remote control 1, simultaneously press and hold the
head up and flat buttons (FIGURE 22) until the indicator
light goes off on the control box.
STEP 10
Repeat Steps 5 & 6 with base 2 and remote control 2.
Independent remote control operation is now
restored (remote control 1 operating base 1; remote
control 2 operating base 2).
HEAD UP
BUTTON
FIGURE 22
BASE 1
BASE 2
CONTROL BOX
INDICATOR
LIGHT
LEARN
PORT
FLAT
BUTTON