Installing The Movement Arm - Precor Discovery Plate Loaded Serie Manual Del Propietário

Installing the Movement Arm

Before you attach the movement arm to the vertical frame, you must insert an
axle.
To insert the axle into the movement arm:
1. Slide the axle into the movement arm sleeve.
Figure 5: Axle and stop ring installation
2. Center the axle within the movement arm sleeve, then place a stop ring
over each end of the axle. Slide the stop rings as far in as they will go.
Calf Raise Assembly Guide: Assembling the Equipment
To attach the movement arm to the vertical frame:
1. Gently fit the movement arm into the bracket underneath the vertical
frame.
2. Attach the movement arm using two M12 x 35 mm socket head cap
screws and two 13 mm flat washers.
Important: The screws should be tight enough to prevent the movement arm
from rocking from side to side when in use.
Figure 6: Movement arm attachment
8