miniland baby Everywhere Manual De Usuario página 19

en
you wish to configure it must be connected to the same network as the latter.
Connect one end of the network cable provided to the network connector of the
camera (7) and the other end to one of the network connectors of the router. For the
camera working on a wireless basis, connected to the router via Wi-Fi, follow the
steps shown below.
Android
1. If you click on 'Manage WiFi Networks', the device will automatically scan the
networks available.
2. Select the required network and enter the password.
3. Click 'OK' and wait until the device says it is connected.
iOS
1. Click on the 'WiFi' button and the device will automatically scan the networks
available.
2. Select the required network and enter the password.
3. Click on Connect.
The camera will then be configured to work on wireless mode. Disconnect the network
cable from the camera and it will continue to work while connected to the selected
WiFi network.
It will only be necessary to repeat this step when you connect the camera for
the first time to a new router or when you turn off your router.
- Sound detection
This characteristic serves for the camera detecting whether the baby is moving. You
may deactivate this function or activate it with different sensitivities: Low, Medium,
High and Maximum. If your baby usually moves around a lot whilst he/she sleeps,
choose a low sensitivity. If, by contrast, he/she only moves when he/she wakes up
and needs something, choose a higher sensitivity.
- Recording mode
This mode allows the baby to be recorded when motion is detected, hence, for it to
work, it must have both the motion detection option (see previous point above) as well
as the recording mode activated. If, by contrast, you don't wish to record, you will only
have to deactivate the recording mode.
In order to record the camera must also have a microSD card inserted (not included).
To insert the card, follow the steps below:
1- Turn off the camera.
2- Enter the microSD card in the corresponding slot (11).
3- Connect the camera after entering the card.
One the card has been entered, it must be formatted so that the camera can record
on it. See the steps to be followed in the "Formatting the SD card section" section.
- Notifications
On this menu you can choose which type of notification you wish the application to
use to warn you when there is a motion detection event. You can choose between 4
options:
19