Troubleshooting Guide - Stanley ST-60HB2-GFA Manual De Usuario E Instrucciones De Funcionamiento

Problem
Fan does not turn when electricity
is connected.
Heater will not fire (ignite).
Heater stops running
by itself.
© 2018 Pinnacle Climate Technologies Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE

TROUBLESHOOTING GUIDE

Possible Cause(s)
1. No electric power to heater.
2. Power switch is off.
3. Blades of fan in contact with heater
housing.
4. Fan blades bent.
5. Fan motor defective.
1. No spark at module.
2. Incorrect spark gap.
3. Corroded electrode.
1. Temperature inside heater is too high,
causing thermal switch to shut down
operation.
2. Dust or debris accumulated
in heater.
CONNECTED TO A POWER SOURCE
1. Check current at outlet. If voltage is
2. Press red power switch to ON.
3. Check housing for damage. Be sure
4. Straighten all fan blades.
5. Replace motor assembly.
1. Inspect module wire. Reattach or
2. Set plug gap to 0.16" (4 mm).
3. Clean electrode.
1. If the heater input or output is
2. Clean inside of heater.
10
Propane Forced Air Heater User's Manual (ST-60HB2-GFA)
Solution
correct, inspect extension and power
cords for cuts, frays or breaks.
there are no dents in the housing
obstructing the fan.
tighten if loose. Inspect spark module.
Inspect all other electrical components.
restricted, the inside temperature can
become too hot. Keep the areas in front
and behind heater clear of obstructions.