Abridged Manual - Sw22 / Sw23 - Julabo SW22 Manual De Operación

Abridged Manual - SW22 / SW23

 Preparations: Installation, filling and power connection see operating manual.
Minimum filling level: 7 cm (level approx. 3 cm above surface (16) for the
placement of items/fixtures)
 Mains switch (on / off)
 MULTI-DISPLAY (LED)
- operating temperature value
- high-/ low temperature value
- operating time
- shaking frequency
Each value is available on call: it may be activated, stored
and indicated on the LED-display .
Setting operating temperature values:

setpoint temperature
• Press the key. The indicator light blinks and the value previously set appears on the
MULTI-DISPLAY (LED).
If no further key is pressed the display will return to show the actual bath temperature
after approx. 8 seconds.
• Use the cursor keys
until the numeral value you wish to change is blinking.
• Use the edit keys
(1, 2, 3, ... 9).
• Press the enter key
Setting the warning functions and electronc timer:
 High temperature setpoint
 Low temperature setpoint
 Operating time
 Shaking frequency
Indication of
in °C or °F,
in °C or °F,
in h:m
in rpm
to move left or right on MULTI-DISPLAY
to increase or decrease the numeral value
to store the value.
(see )
(see )
(see )
(see )
Shaking Water Baths
see rear of page
Acoustical signals see
rear of page.
))

47