Idiomas disponibles
Idiomas disponibles
A
WARNING
, 1 10
Electric Shock Hazard
Unplug unit before performing
any maintenace
Never use a water hose or pres-
sure washer to clean coils: water
could enter the electrical cam-
partment causing a shock haz-
ard
Follow cleaning instructions in
manual.
Error Message Table
Problem with electronic
ER
control panel Contact Dri-
1,2 3
5.
"
Eaz Service at 888-S67-
6
3235.
ER 4
Check the temperature or
sensor cable, contact
Service for instructions
888-867-3235.
ER 8
Check the touchpad key.
Press and release each
key several times
ER 9
Check for obstructions or
kinks in the drain hose.
141 Kinderkarnack Rd. Park Ridge, NJ 07656 Tel. 201-782-1782 Fax. 201-782-1783 Web www amgair corn
READ AND SAVE THESE INSTRUCTIONS
0
PURGE.
reservoir. During normal operation. the pump purges automatically
every six minutes, or whenever the reservoir is full. The display will
read PUMP PURGING with a numeral countdown.
To purae the Dump manually:
1) Turn the power off using the OFF key. and let the unit sit
2) Press PURGE to remove residual water.
Other displays
Defrost Cycle
During normal operation, the temperature sensor detects frost forming on the
coils, causing a defrost cycle to start. The display will read DEFROST ON.
Dehumidification stops during the defrost cylce. When the unit completes the
cycle the display will return to DEHUMEIER ON.
Messages
When the display menu shows the error message "GET SERVICE." followed
by "ER01" or another numeral. follow these steps:
1. Unplug the unit and then plug it back in. This may re-set the
2. If that does not fix the problem. try the solution if one is listed in
3. If that does not fix the problem, contact the Dri-Eaz Service
Unplug
MAINTENANCE INTERVALS
Before Each
• Inspect the electrical cord for damacie. Look for fraying, cuts. etc. Do not
use the unit if you find any Call Dri-Eaz for the nearest Service Center.
• Inspect filter. Look for accumulated dust and dirt that would resthct airflow
through the filter into the unit. If any is visible, vacuum out the debris. Do
not wash the filter, as it will reduce the effectiveness of the electrostatic
material.
IMPORTANT:
Air Marketing Group ELC
Press the PURGE key to empty water from the pump
plugged in for about 10 minutes. This allows water to drip
from the coils.
electronics.
the "Error Message Table" to the left.
Department at 888-867-3235.
Maintenance
WARNING
A
ELECTRIC SHOCK HAZARD
dehumidifier before performing maintenance.
any DrizAir
Use
Replace the filter whenever:
• It has been vacuumed clean 3 times
• It has been used on a mold remediation job
5
info@arngair con]
