Trouble Shooting Esc Brushless - Carson Brushless Speed Controller Dragster 6S Manual De Instrucciones

h. Trouble Shooting ESC Brushless
Trouble
After power on, motor doesn't
work
GB
After power on, motor doesn't
work, but emits "beep-beep-,
beep-beep-" alert tones
(Every group of "beep-beep-"
has a time interval of 1 second)
After power on, red LED always
lights, the motor doesn't work
The motor runs in the opposite
direction when it is accelerated
The motor suddenly stops
running
When accelerating quickly, the
motor stops or trembles
28 CARSON Brushless Speed Controller Dragster 6S
Possible reason
The connections between
battery pack and ESC are not
correct
Input voltage is abnormal, too
high or too low
Throttle signal is abnormal
The wire connections between
ESC and the motor are not
correct
The throttle signal is lost
The ESC has entered the
"Low voltage protection mode"
or "Over-heat protection mode"
1. The battery has a bad
discharge performance
2. The "Start mode (Punch)" of
the ESC is too aggressive
Solution
Check the power connections
Replace the connectors
Check the adjustment of the
voltage of the battery pack
Plug the receiver wire into the
throttle channel of the receiver
correctly
Swap any two wire connections
between the ESC and the motor
Check the transmitter and the
receiver
Red LED flashing means
"Low voltage protection". Please
replace battery pack.
Green LED flashing means
"Over-heat protection", please
stop running to cool the ESC.
Use a better battery
Select a softer option for the
"Start mode (Punch)"