Carson Brushless Speed Controller Dragster 6S Manual De Instrucciones página 22

Note 1
The "SET" key of ESC is at the power switch (see
picture).
GB
Press and hold
Hold SET key
Release SET button once the red LED starts to flash.
C) Set the 3 points according to the steps.
1. The neutral point
Move the throttle lever at the neutral point, and
then click the SET key. The green LED flashes
1 time.
2. The end point of forward
direction
Move the throttle lever at the end point of
forward direction, and then click the SET key, the
green LED flashes 2 times.
22 CARSON Brushless Speed Controller Dragster 6S
Hold
Switch on ESC
3. The end point of backward
Move the throttle lever at the end point of
backward direction, and then click the SET key,
the green LED flashes 3 times.
The throttle range is calibrated; the motor can
be started after 3 seconds.
Note 2
If you don't release the "SET" key as soon as the red
LED begins to flash, the ESC will enter the program
mode. In such case, please switch off the ESC and
re-calibrate the throttle range again as described.
direction