Installing The Canopy Housing; Mounting The Fan Blades - Fanimation The Islander FP3201 Serie El Manual Del Propietario

NOTE: This step is applicable after the neccessary wiring
is completed. (see pages 7)
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Screw in two threaded rods into the Hanger Bracket
(Figure 10a).
NOTE: The threaded rods in the hanger bracket serves as
guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled knobs
supplied with your fan (Figure 10b).
You will fi nd the fan blade set packed in its own carton and the blade holders and hardware bag in the upper foam packing
in the fan box. The hardware bag for the blade holders consists of 10 screws and a Phillips head screwdriver.
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
1. Lay side "A" of the blade holder on a flat surface with the
inside of the blade holder facing up. This is the side with
the threaded posts and pitched foot (Figure 11).
2. Position the palm leaf, or the woven bamboo blade, or
the wicker blade over the blade holder with the threaded
posts showing. Make sure the bottom edge of the blade is
fully seated against the blade holder.
3. Place side "B" of the blade holder on top of the blade,
positioning the holes over the threaded posts.
4. With a Philips screwdriver, thread both screws into the
posts but do not fully tighten.
5. Prior to final tightening, position the centerline of the
blade holder with the center of the end of the blade.
6. Tighten both screws to secure the blade. (Figure 12)
INSTALLATION NOTE
Attach the Blades to the Rubber Flywheel using the
holes marked #5 for 5-blade application. For 4-blade
application, use the holes marked #4.

Installing the Canopy Housing

Mounting the Fan Blades

NOTE: Supply wires and fan wires omitted for clarity.
Figure 10a
Fan Blade
NOTE: Optional Wood blades and Blades Holders,
Canvas blades and The Ococee™ kayak oar blades are
available for this assembly.
Flywheel
Blade Holder
Screw
(2 per blade holder)
8
Figure 10b
Side B
Figure 11
Figure 12
Side A