Faber Opti-V Fire PGF20 Manual De Instrucciones página 9

Idiomas disponibles
  • ES

Idiomas disponibles

Opti-V Fire : PGF 20
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Contents of Carton
Opti-V Fire Model PGF20
Remote control and batteries (AAA type)
Important Safety Advice
When using electrical appliances, basic precautions
should be followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:
If the appliance is damaged, check immediately with the
supplier before installation and operation.
Do not use this appliance in the immediate surroundings
of a bath, shower or swimming pool.
Means for disconnection must be incorporated in the fixed
wiring in accordance with the wiring regulations.
Do not use outdoors.
In the event of a fault switch off the appliance.
Switch off the appliance when not required for long periods.
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the manufacturer
or its service agent.
Warning - No naked flame sources, such as candles,
should be placed on this apparatus.
Warning - The appliance shall not be exposed to dripping
or splashing and that no objects filled with liquid, such as
vases, shall be placed on the apparatus.
Warning - this appliance is of Class I construction and
must be connected to a mains outlet with protective
earthing connection.
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED
Do not switch the appliance on until properly installed. Please
read all the safety warnings and operating instructions.
Installation
Warning.
Do not connect the appliance until properly fixed to a secure
base and the instruction leaflet is read fully.
At installation of the appliance, care must be taken not to
damage any cables that may be concealed in the wall.
Please be careful while drilling the holes.
These models are designed to be permanently fixed
for optimum viewing of the display screen see Fig.2a and 2b.
Dimensions indicated * are recommended
dimensions from floor to underside of the wall aperture -
65cm for viewing in a seated position and 110cm for viewing
in a standing position. The outline of the chassis and the
position of the electrical socket are shown as dotted outlines
in Fig.4. Please consult with a qualified electrician for
appropriate wiring requirements.
Operation: -
The power 'ON' switch ('O/I'see Fig.3) must first be switched
'I' to operate the appliance.
The 'Opti-V' logo will appear for about 3 seconds before the
flame picture starts .
Note: The user may notice a blank screen for approximately
5 seconds, every 30 minutes. This is normal and should not
be a cause for concern.
Manual Control Operation: -
The manual controls for the screen are located at the inner
top left hand side of the appliance above the glass.(see Fig.3).
The appliance Power switch ('O/I' see Fig.3) may be used to
switch the appliance off ('O') when it is not required, for
example, overnight or for long periods, to avoid energy
wastage.
The standby button (
switch.
Remote Control Operation: -
The remote control may be operated once the appliance is
switched 'I' ('I' see Fig.3). A red light will indicate when the
appliance is in standby mode.
control at the screen (I.R. sensor is indicated in Fig. 4). The
audio volume may be adjusted up or down by pressing the
volume control buttons ( + and -). For installing or replacing
the AAA batteries into the remote control - see Fig. 5.
Techical Information:
230V 50Hz
Power consumption
Power on Stand-by
Cleaning
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass screen should be cleaned
carefully with a soft cloth. DO NOT use proprietary glass
cleaners.
Warranty and Service
For service and warranty of the product log onto the website
http://www.gdbservice.com/
select Faber and select 'Electric'. Select model Opti-V Fire
PGF20. The series number of the product can be found on
the label on the right hand side of the product above the
glass. Please retain your receipt as proof of purchase.
fixing
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should
not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
4
) is located just below the mains
(See Fig.4)
Aim the remote
0,04KW
1W
UK
loading