Installation; Introduction; Maintenance Space; Connections - S&P CADB-D Serie Manual De Instalación, Uso Y Mantenimiento

7. INSTALLATION

7.1. INTRODUCTION

Horizontally configured models are designed to be installed hanging from the ceiling or located inside a false ceiling.
The appliance has four metal abutments, one on each lower corner. Using studded rods (Ø 6 mm or Ø 8 mm), it can be secured to the ceiling
and levelled.

7.2. MAINTENANCE SPACE

Horizontal
B D
Vertical
B

7.3. CONNECTIONS

7.3.1. PIPING AND DUCT CONNECTIONS

7.3.1.1. CONNECTION WITH AIR DUCT

The standard configuration displays the route of fresh air blown into the premises in blue, while used air and its route until it is expelled from the
premised is in red.
The fans are always blowing out with regard to the machine.
The fans must not be positioned in a manner different to the one indicated.
The installer must make sure that the ceiling structure and the
securing elements can bear the weight of the device, taking into
account that it is a dynamic load.
Vertical configuration models have special support feet.
Once the device has been fitted in the correct position, the installer
must connect it with the air duct, the mains connection, both for the
motors, and for the batteries, if applicable, by means of the terminals
in the terminal connection box and the connection with the hot water
closed circuit for the water battery, if applicable. The tube for evacua-
ting condensates will be secured according to the instructions in the
corresponding section.
B D B
A
17
A B C
Model
(mm) (mm) (mm)
CADB-D/DI/DC 05 345 400 400
CADB-D/DI/DC 08 360 400 400
CADB-D/DI/DC 18 535 400 600
CADB-D/DI/DC 30 630 500 700
CADT-D/DI/DC 45 855 500 900
CADT-D/DI/DC 56 855 500 900
A B
Model
(mm) (mm)
CADB-D/DI/DC 05 400 640
CADB-D/DI/DC 08 400 820
CADB-D/DI/DC 18 600 1040
CADB-D/DI/DC 30 700 1270
CADT-D/DI/DC 45 900 1300
CADT-D/DI/DC 56 900 1300
D
(mm)
640
820
1040
1270
1300
1300
C
(mm)
740
920
1140
1370
1300
1300