Leggett & Platt Premier Serie Manual Del Usaurio página 6

Table of Contents
TANDEM SYNCING
4. Make sure the PRI/SEC button (Port 13) is in the full out position on base
1. This is primary mode (FIGURES 3 and 4). Note: Base comes factory
programmed in primary mode.
5. Push the PRI/SEC button (Port 13) in for secondary mode on base 2 (FIGURE 3).
The LED next to the button should trun ON (amber in color).
FIGURE 3
6. Position both bases so they are sitting on their legs.
7. Plug base 1 (primary base) back into working, grounded electrical power source,
making sure to avoid making contact with the surround at that time, as this will trip
LP Sense™.
8. Pair tablet to base 1, as instructed on next page. Base 2 (secondary base)
automatically pairs to tablet through sync (CAN BUS) cable once base 1
(primary base) is programmed.
6
(two Split-King bases operate as one base)
CONTROL BOX
PRI/SEC button (Port 13)
(push in for secondary mode)
IF LP SENSE™ GETS TRIPPED DURING
PROCEDURE, EITHER UNPLUG THE BASE, WAIT
15 SECONDS, THEN PLUG IT BACK IN, OR WAIT 5
SECONDS AND THE BASE WILL RESET ITSELF.
FIGURE 4
(OUT)
PRIMARY
MODE
PRI/SEC
BUTTON
(IN)
SECONDARY
MODE
PRI/SEC
BUTTON
IN SECONDARY MODE, THE LEARN
BUTTON IS PRESSED FARTHER IN
THAN IN PRIMARY MODE
Continued on next page...