Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10. CONNECT WIRING
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applic-
able codes and standards. Before connecting wires, switch power off at service panel and lock
service disconnecting means to prevent power from being switched on accidentally.
ALL INSTALLATIONS:
Punch out the knock-out hole(s) located on back side of the insert.
NOTE: Punch (1) hole for interior blower installation or (2) holes for exterior blower or in-line blower installation.
Remove the insert wiring box cover. Remove both flexible wire sleeves from the wiring box and keep for further use. Install one
wire clamp (A) on the back side of the insert and the other in the knock-out hole of the wiring box. Position insert below the
installed custom hood. Slide the power cable into one of the wire sleeves (B) provided. Pass power cable with sleeve through
the wire clamp on the back side of the insert and through the wire clamp in the wiring box. Tighten both wire clamps completely
to secure the cable. The wire sleeve ends must be secured by the wire clamps. Connect cable into wiring box using provided
waterproof wire connectors.
W
ATERPROOF WIRE CONNECTORS INSTRUCTIONS
1 Strip wires 3/8".
2. Align frayed strands or conductors.
3. Do not pre-twist. Place stripped wires together with ends even, but lead smaller
stranded wires slightly ahead of larger solid or stranded wire.
4. Twist connector onto wires pushing firmly until hand-tight. DO NOT over torque.
5. When inserting wires into connectors, some sealant may leak out. Wipe off excess
sealant in and around conductors. DO NOT REUSE.
Do not connect the WHITE wires yet.
Connect wires as follow: BLACK to BLACK (C) and GREEN or BARE wire under ground screw (D). DO NOT FORGET TO
CONNECT THE GROUND. Do not reinstall the wiring box cover yet.
EXTERIOR OR IN-LINE BLOWER INSTALLATION ONLY:
Install a wire clamp (not provided) in the knock-out hole beside the wire clamp on the back of
the insert. Slide the power cable into the other wire sleeve (E) (provided). Pass the exterior blower
cable with sleeve through the wire clamp and tighten to secure the blower cable. The wire sleeve
end must be tightened by the wire clamp.
Pass the blower cable (with its sleeve) through the plastic clamp (F) in the wiring box.
Completely tighten the plastic clamp. See figure at right.
Connect blower cable into wiring box using provided waterproof wire connectors.
NOTE: Refer to the W
ATERPROOF WIRE CONNECTORS INSTRUCTIONS
perform proper connectors installation.
Connect wires as follow: BLACK to ORANGE (G), WHITE to 2 other WHITE wires (H), and
GREEN under ground screw (I). DO NOT FORGET TO CONNECT THE GROUND.
Reinstall the wiring box cover.
WARNING
!
:
CAUTION
box (earlier in this page) to
- 7 -
B
A
HE0034
F
Not completely
tightened
VO0084
G
I
HE0033
C
D
A
Completely
tightened
E
F
H
Tabla de contenido
