Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using the
dimensions shown at right.
NOTES: 1. The recommended distance from the back to the rearmost
cutout edge is 2¼" minimum.
2. When cutting the 10¾'' notch for the wiring, also notch out the
rear stud or provide clearance for the wiring.
7. INSTALL THE EXTERNAL BLOWER (EB12, EB15 OR ILB11 MODELS ONLY)
Refer to instructions packed with EB12, EB15 or ILB11 external blowers and follow steps 10, 11, 12, 13, 15 and up of this
manual.
8. INSTALL THE ROUGH-IN PLATE
(USE WITH INTERIOR BLOWER P8D MODEL ONLY)
Hang the rough-in plate onto the insert inner top (screws through the large
part of the keyhole). Slide the rough-in plate toward the rear of insert (screws
in the smaller part of the keyhole). Tighten the (4) screws.
9. INSTALL THE DEVIATOR
(USE WITH INTERIOR BLOWER P8D MODEL ONLY)
Slide the deviator inside the insert as shown.
NOTE: If installed correctly, the deviator will protrude about 1/8" above the insert.
16½"
2¼"
min.
HD0101A
HO0023
HO0022
- 6 -
32½"
11/16"
10¾"
Tabla de contenido
