Cebora 125.00. Manual De Istrucciones página 19

CEBORA S.p.A
13.5 Current (PLASMA).
Indicates the Cutting Current expressed in
absolute value.
The allowed range is shown on the line.
The corresponding Robot Interface Analogue
Output voltage has the following ratio:
- 0 ÷ 300 A Arc Current = 0 ÷ 10 V Robot
Interface output voltage.
13.6 Voltage (PLASMA).
Indicates the Arc Voltage expressed in absolute
value.
The allowed range is shown on the line.
The corresponding Robot Interface Analogue
Output voltage has the following ratio:
- 0,0 ÷ 250,0 V output voltage = 0 ÷ 10 V
Robot Interface output voltage.
3.300.125-C
14 LOG WINDOW DESCRIPTION.
Log Window (fig 6) contents information
referred to modified parameters variations, with
the following indication for each parameter:
- Parameter new value;
- Parameter type;
- Transmission time (dd/mm/yyyy hh:mm:ss).
Included the list are the five operative status
displayed in the Main Page Status Bar.
Filters to select the parameter type to visualize
are available to improve the reading.
In the Log Window bottom side are three
command buttons:
- Clear, to clear the Log Window data;
- Save, to save in a Log File the Log Window
content;
- Close, to close the Log Window.
Therefore by typing CTRL+F10 are displayed
debug information to check the communication
line.
The Log Page can acquire up to maximum 5000
record lines, after that the recording continue in
FIFO mode (First-in First-out).
19
GB
04/03/2016