Lubrication; Pendulum Replacement - Cosmo PDC 400 Manual De Uso

6.1.

LUBRICATION

Before every use and after every 8 hours of effective work, carry out the
greasing of the gear box.
It is a good use that the greasing nipples are well cleaned up from mud or
other residuals before using them for inject lubricating grease.
Lubricate with lithium grease the different 5 points, shown in the picture.
One of the grease nipples is located behind the capsule for the closing of the protecting cap of the
lubricating mechanism:
• Take off the capsule for the closing of the distribution mechanism.
• Move the oscillating tube until you can reach the grease nipple from the opening of the protecting
cap.
• Lubricate all the nipples 1 or 2 times.
• Place again the capsule for the closing on the protecting cap.
6.2.

PENDULUM REPLACEMENT

In case the pendulum breaks or gets damaged, it will be necessary to replace it with an original one
supplied by the Manufacturer.
Insert the aluminium flange on the pendulum base, insert the
fixing screws (A) and the relative nuts, one by side, and screw up
them with two wrenches.
All the fixing devices (screws and nuts) must be the same the
Manufacturer prescribed.
Pendular Spreader PDV - PDHV models 26